The Drive Rite Semi Air Kit is suitable for the following vehicles:-
Mercedes Sprinter 209-324 2006 Onwards 3 Series
Mercedes Sprinter 309-324 2006 Onwards
VW Crafter 28-35 (ABS Vehicles Only) 2006-2016
Suitable for ‘van’ models with rear overhang up to 1.5m.
- For ‘van’ model vehicles with rear overhang over 1.5m use DR.02.003502.
- For all ‘chassis’ model vehicles use DR.02.003502
This is a complete air suspension kit including both the air suspension system i.e. bellows, piping and valves as well as the additional gauge and controls.
Designed to fit standard none extended al-ko chassis, to fit to vehicles with leaf springs.
FIRESTONE Air Bellows are used in this air suspension kit
This kit is simple to install and can be undertaken by any DIY capable person
Optional DRV003 gauge addon
MAINTAIN CORRECT VEHICLE HEIGHT
Improve steering control and braking effectiveness, level headlight beams and reduce tyre wear.
LEVEL OFF-CENTRE LOADS
Individual inflation valves allow for adjustment side-to-side.
NO MORE SPRING SAG
Keep leaf springs from permanent sagging under repeated or constant load.
SAFER LOAD CARRYING
Protective air cushion softens contact between the axle and frame.
IMPROVED STEERING & HANDLING
Absorbing road shock providing ideal ride conditions for passengers and load.
EUROPEAN DESIGNED, MANUFACTURED, TESTED & APPROVED
All Drive rite kits are designed, manufactured, tested and approved to the highest standard.
Installations typically require no drilling
Reduces suspension fatigue and bottoming out while increasing comfort and stability
Enables side to side levelling to allow for off centre loads, each air bag is independent to the other side.
Mounts between chassis and original suspension
The original suspension is not removed, only the bump stop itself. The semi-air systems are designed to work together with the original suspension
The Driverite air suspension can be adjusted to bring the vehicle to ride height regardless of the load (Do not exceed the Gross Vehicle Weight-GVW)
All Drive rite air kits come with two inflation schrader valves that allow for manual inflation in a similar fashion to inflating a car tyre at a service station.
The optional basic compressor and single gauge kit allows the operator to adjust the pressure. There is no need to drive to a service station as the compressor feeds directly into the air bag.
The air bellows can be inflated independently to balance the motorhome depending on loading situations.
Specifications
Cross Reference Kit Number | W21-760-3500 |
European / US Vehicle | Europe |
Average Installation Time | 1 – 2 hours |
Reviews
There are no reviews yet.